Mach 2018

09-13 April 2018

nec birmingham uk

Lloyds Bank

sub hero

MSP help Formula 1 team reduce part set-up by 9.5 hours

MSP help Formula 1 team reduce part set-up by 9.5 hours

23-Jan-2018 METROLOGY SOFTWARE PRODUCTS LTD

Challenge
A leading Formula 1 team were suffering from long part set-up times before machining complex aero components for their car, such as the chassis, nose cone or front wing. Part set-up has to be accurate as the machining process involves trimming the carbon fibre to tight tolerances and drilling holes at micron precise locations. The company’s manual procedure was extremely time consuming to ensure this accurate part set-up.
Their process involved placing the part in the fixture on the machine, then manually probing it to ensure it had been made correctly and positioned correctly on the machine. The team were probing the parts using manual probing cycles. This involved probing control points one point at a time and recording each result manually.
If any errors were present, the part would have to be moved manually on the machine. Each point would be probed again and each new result written down. This process would be repeated until each point was correct. This was taking up to ten hours and long past some operators shifts.
The handwritten results would then have to be collated and emailed to the designer so it could be approved before any machining took place. Due to the length of the process, designers could be receiving emails any time day or night.
Solution
MSP recognised their NC-Checker and NC-PerfectPart software could save a significant amount of time in set-up and give the operators significant control over their process.
NC-Checker makes it possible for operators to identify and remove errors on the machine and make the machine more accurate overall. The software’s benchmark reports also allow them to keep
track of the machines performance over time and schedule in maintenance when necessary.
NC-PerfectPart eliminates all manual elements from the process.
The software automates the probing cycle, allowing all points to be taken at once, with no manual intervention. It produces a print-out report of the probing data, making it easy for operators to send the results to the designers, at a designated time if necessary.
NC-PerfectPart auto aligns the machine to the part, eliminating the need to manually move the part around to the correct position.
Its Pre-Machining Verification report shows if the part’s alignment is valid and if it has been made correctly and good enough to machine in the first place. This reduces the risk of machining the part incorrectly and having to scrap it afterwards. Chassis production is restricted due to F1 regulations. It is therefore crucial To reduce long part set-up times and automate manual processes
Result:
Part set-up was reduced from 10 hours to 38 minutes every time every chassis is correct and zero are scrapped.
Results
Using MSP’s software, part set-up could be automated and errors could be accounted for by aligning the machine to the part, instead of the other way around. This significantly reduced the team’s set-up time from 10 hours to just 38 minutes each time. This impressive time saving means productivity has improved greatly and has allowed the team to get their designs through production onto the track at record times. As much less time is required on the machine (see Figure 1), it is freed up to perform other machining tasks. Furthermore, the fixed set-up time gives operators much more control over machine scheduling and means they can provide accurate delivery times.
Another benefit is the paper trail aspect of the software, as the operators no longer need to record any data manually and, as a result, can send the designer a full probing report effortlessly; at a sensible time of day.

Loading

MEDIA PARTNERS